The Power Glove Badge

🕹️ The Power Glove Badge with 0.91" OLED Screen

"I love the Power Glove... it's so bad." 🎮 3D-shaped retro badge inspired by the legendary film The Wizard (Did you know that an extended version of that movie exists?!) Features a 0.91" OLED screen, 3 custom push buttons, 3D-printed screen cover, and SAO connector. Perfect for Defcon!

Description

Designed as a homage to the iconic movie The Wizard, that I love, and the ultimate retrogaming controller.

Key Features

ATtiny1616 Powered: Driven by a ATtiny1616 microcontroller running custom animations and display logic.
0.91" OLED Display: OLED display showing custom animations, texts, and interactive messages.
3 Tactile Buttons: Cycle through messages using 3 distinct colored buttons (Black, Blue, and Red) directly on the board.
3D-Printed Protective Case Included: Includes a custom 3D-printed protective cover for the OLED screen that can be placed on top or glued directly to the PCB.
Dual Power Modes: Power it via a standard SAO connector or a rechargeable coin cell battery (LIR2032).

Package Includes

1x Power Glove Electronic Badge (Fully assembled and tested)
1x Custom 3D-printed OLED screen protective case
Instructions for the badge

⚡ BATTERY REQUIREMENT (LIR2032 ONLY)

REQUIRES LIR2032 (3.6V): If you plan to power the badge using a battery, you MUST use a rechargeable LIR2032 (3.6V) ONLY.
DO NOT USE STANDARD CR2032 (3.0V): Standard non-rechargeable CR2032 batteries WILL NOT WORK due to insufficient voltage and current needed to boot the OLED screen.
Battery NOT Included: The battery is not included due to international lithium shipping restrictions.

💡 POWER & SAFETY NOTE

Protection Diode Included: This PCB features an onboard reverse-current protection diode, preventing hardware damage when switching between power sources.
Dual Power Modes: Safe to power via either an SAO connector or a rechargeable LIR2032 (3.6V) battery.